Over 15,000 combinations of shafts and heads



We have transformed the typical club fitting experience into a personalised, science based craft.


After the fitting session, we will proceed by ordering the components, club heads, shafts & grips to begin the build process in our state-of-the-art workshop.


To establish a benchmark of a client’s current clubs, we use TrackMan IV launch monitor technology to measure spin rates, launch angles, total carry, total distance, shot dispersion & more.


To identify the correct shafts, use of the MaxOut shaft loading system, as used by some of the top club fitters in the world, is then implemented to identify the exact personalised shaft bend profile required by the client.  Pure Golf Stackstown is the only facility in Ireland to use this system. 

Another first in Ireland at Pure Golf Stackstown is SST PURE Shaft Alignment & Analysis. Being the only facility in the country to offer this service, clients can have the peace of mind that every club that we build has a shaft that is placed into the clubhead at the exact angle to guarantee the most consistent & repeatable ball contact possible. 

Pricing Below (Cost of fitting session is deducted upon purchase of clubs)

Wood Fitting

Iron Fitting 

Wedge Fitting

Putter Fitting

Golf Ball Fitting



Golf shafts aren’t perfectly straight or perfectly round. Studies have shown that irregularities in a shaft’s structure cause off-line bending and twisting during the golf swing. This causes an increase in shot dispersion or, in irons,  inconsistent performance from club to club. The SST PURE® Shaft Alignment System analyzes the structure of any golf shaft and identifies its most stable bending plane, or Neutral-Axis™. When assembled in the clubhead in this SST PUREd® orientation, the result is improved consistency from club to club within your set and set to set within your brand